RCF HL 6 16ohm

• 500W Program power handling
• 131 dB max SPL
• 65 Hz to 20 kHz frequency range
• 100 x 10° coverage angles
• Fully equipped with neodymium transducers
• Horn-loaded symmetric design
• Wooden reinforced polypropylene enclosure
• Steel grille with clothing
• Two speakON connectors

The RCF HL 6 features RCF transducers with neodymium magnets. RCF’s experienced engineering teams have specially developed and matched each component. An entire set of protections preserve product life and reliability. 

High frequencies

• High-performance RCF ND840
• 1.75-inch diaphragm neodymium compression driver
• 900 Hz crossover point

Low frequencies

• Two 6” neodymium woofers
• Low frequencies handling down to 65 Hz
• Water resistant fiber doped cone
• Polycotton M-roll surround
• Hypervented magnetic structure

The custom-designed waveguide allows a precise coverage of 100 x 10°, while also delivering a completely linear high-frequency response. The constant directivity waveguide delivers consistent coverage from 900 Hz to the highest audible frequencies.

The passive architecture makes the HL 6 one of the lightest line array modules on the market. Combined with flexible rigging options and a wide range of accessories, it’s the ideal line array for installation both in corporate environments, and music venues. HL 6 provides plenty of sound pressure and clarity that can replace antiquated, oversized sound systems with improved acoustic performance.

• The integrated fittings are both easy to use and reconfigurable, allowing the system engineer to create J-shaped and spiral arrays starting at 1° angle.
• The hardware is designed for easy and fast setup. Up to 16 HL 6 modules can be fastened on a single flybar.
• The heavy-duty front grille is powder coated. A special transparent-to-sound foam backing inside helps to further protect the transducers from dust and debris.

Perfect for keeping the floor clear and maximizing the efficiency and coherence of the array, the low-frequency companion designed for the HL 6 is the high-performance flyable single 15″ HL 35-S. The integrated fittings are both easy to use and reconfigurable, allowing the system engineer to extend the HL 6 lower range with one or multiple HL 35-S modules. It can be used attached to the flybar, on the floor, or stacked with the HL 6 on top. HL 35-S provides sound pressure and clarity that can replace antiquated, oversized sound systems with improved acoustic performance.