Specifications
Main unit
Power supply AC 200V-240V, 7.7A, 50 / 60Hz
The light output will decrease to approximately 1/2 when using the projector with
AC 100V to AC 120V [9.6A].
Power consumption 1,510 W (1,525 VA [AC200V]) (0.3 W with Standby Mode set to Eco * 1,
4 W with Standby Mode set to Normal)
1,217W (Normal Mode), 972 W (Eco Mode)
Operating Temperature: 25 ° C (77 ° F), Altitude: 700m (2.297ft),
IEC627087: 2008 Broadcast contents, Picture mode: Standard, Dynamic contrast [2]
BTU value Max 5,159 BTU
DLP ™ chip Panel size 24.1 mm (0.95 inches) diagonal (4 : 3 aspect ratio)
Display method DLP ™ chip × 3, DLP ™ projection system
Pixels 4,410,000 (1400 x 1050 x 3) pixels
Refresh rate 120 Hz * 2
Lens Optional (no lens included with this model), powered zoom, powered focus lens
Light source Laser Diode (Laser class: Class 1) * Class 3R for North America.
Illumination life of set Varies depending on operation mode setting.
20,000 hours at half luminance (Normal) 24,000 hours at half luminance (Eco)
* IEC62087: 2008 Broadcast contents, Dynamic contrast [3]
(NORMAL / ECO Temperature: 30 ° C (86 ° F), Altitude 700m (2.297 ft), Dynamic
Contrast [3] Under conditions of 0.15 mg / m3 of particulate matter
Screen size (diagonal) 1.78–25.4 m (70–1,000 in) with 4: 3 aspect ratio
1.78–15.24 m (70–600 in) with the ET- D75LE8, 4: 3 aspect ratio
3.05–15.24 m (120–600 in) with the ET-D75LE95, 4: 3 aspect ratio
Brightness 21,000 lm (Center) * 3 * 5 / 20,000 lm (Normal) * 4 * 5
Center-to-corner uniformity 90%
Contrast * 3 20,000: 1 (Full On / Full Off, Dynamic Contrast Mode: 3)
Resolution 1400 x 1050 pixels
Scanning frequency Video / YC fH: 15.73KHz fV: 59.94Hz, fH: 15.63KHz fV: 50Hz
RGB • Resolution: 640 x 400 pixels to 1920 x 1200 pixels
• Dot clock frequency: 162MHz or less
• PIAS (Panasonic Intelligent Auto Scanning)
YPBPR (YCBCR) • Resolution: 480i / 576i to 1920 x 1080 pixels
• Dot clock frequency: 148.5MHz or less
• The SYNC / HD and VD terminals do not support 3 value SYNC.
DVI • Moving image signal resolution: 480i * 6 / 576i * 6 to 1920×1080
Still image signal resolution: 640 x 400 to 1920 x 1200 (non-interlace)
• Dot clock frequency: 25 MHz to 162 MHz
HDMI / DIGITAL LINK • Moving image signal resolution: 480i * 6 / 576i * 6 to 1920×1080
Still image signal resolution: 640 x 400 to 1920 x 1200 (non-interlace)
• Dot clock frequency : 25 MHz to 162 MHz
SDI SD-SDI signal
HD-SDI signal
3G-SDI signal
Optical axis shift Vertical (from center of screen) ± 50% (± 40% with ET-D75LE6, +67% – +71% with ET -D75LE95) (powered)
Horizontal (from center of screen) ± 30% (± 20% with ET-D75LE6, ± 8% with ET-D75LE95) (powered)
NOTE: Optical axis shift function cannot be operated when used with the ET -D75LE50.
Installation Ceiling / floor, front / rear, free 360-degree installation
Terminals RGB1 IN BNC × 5
R, G, BR: 0.7 Vp-p, 75 ohms,
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B: 0.7 Vp-p, 75 ohms
HD, VD / SYNC: TTL, high impedance, positive / negative automatic
Y, PB, PR (Y, CB, CR) Y: 1.0 Vp-p (including sync signal), PB / PR (CB / CR): 0.7 Vp-p, 75 ohms
Y / CY: 1.0 Vp-p (including sync signal), C: 0.286 Vp-p, 75 ohms
VIDEO IN BNC × 1, 1.0 Vp-p, 75 ohms
RGB2 IN D-sub HD 15-pin (female) × 1
R, G, BR: 0.7 Vp-p, 75 ohms,
G: 0.7 Vp-p (G: 1.0 Vp-p for sync on G), 75 ohms,
B: 0.7 Vp-p, 75 ohms
HD, VD / SYNC: TTL, high impedance, positive / negative automatic
Y, PB, PR (Y, CB, CR) Y: 1.0 Vp-p (including sync signal), PB / PR (CB / CR): 0.7 Vp-p, 75 ohms
DVI-D IN DVI-D 24-pin × 1
Single link, DVI 1.0 compliant, HDCP compatible
HDMI IN HDMI 19-pin x1
HDCP compatible, Deep Color compatible
SDI IN 1 BNC × 1
SD-SDI signal
Technical data
| Brightness | 20,000 |
| Technology | 3DLP |
| Source of light | Laser |
| Contrast | 20,000: 1 |
| Resolution | SXGA (1400×1050) |
| Projection ratio | Depending on the lens |
| Interchangeable lenses | Yes |
| Lens Shift | Vertical ± 50%, Horizontal ± 30% |
| Libra | 49 |
| Brightness Range (ANSI Lumens) | over 15,000 |
