Specifications:
Microphone
- Element:Fixed-charge back plate, permanently polarised condenser
- Polar Pattern:Omnidirectional
- Weight:Microphone, boom & earpiece: 2.6g
- Dimensions:”Microphone: 8.1 mm (0.32″”) long, 2.6 mm (0.10″”) diameter
- Boom: 98.4 mm (3.87″”) long, 1.07 mm (0.04″”) diameter”
- Cable:1.4 m (55″) long (permanently attached to microphone), 1.6 mm (0.06″) diameter, 2-conductor shielded cable with locking 4-pin connector
Overall System
- Operating Frequencies:”UHF band
- 656.125 – 678.500 MHz (D Band)
- 854.900 – 864.900 MHz (F Band)
- 487.125 – 506.500 MHz (I Band)
- 606.500 – 631.000 MHz (U Band)”
- Number Of Channels:10 total
- Frequency Stability:±0.005%, Phase Lock Loop frequency control
- Modulation Mode:FM
- Maximum Deviation:100 Hz to 15,000 Hz
- Operating Range:100 m (300′) typical
- Operating Temperature Range:41° F (5° C) to 113° F (45° C)
Receiver
- Receiving System:True Diversity
- Image Rejection:55 dB nominal, 50 dB minimum
- Sensitivity:20dBµV (S/N 60dB at 5 kHz deviation, IEC-weighted)
- Total Harmonic Distortion:< 1% (at 1 kHz, ±20 kHz deviation)
- Audio Output Attenuator (ATTN) “Unbalanced: 25mV (100k ohms load), 1/4″” phone jack
- Balanced: 50mV (Attenuator; 0dB)
- 12.5mV (Attenuator; -12dB) at 1 kHz ± 5kHz deviation, 100k ohm load, XLRM-type”
- Antenna Input:BNC-type 50 Ohms – Bias voltage 12V DC, 60mA each
- Dimensions:210 mm x 44 mm x 162.2 mm (W x H x D)
- Weight:1.0kg
Belt Pack
- RF Power Output High: 30mW; Low: 10mW, nominal
- Spurious Emissions:According to National Regulations
- Current Consumption:150 mA typical
- Battery Life:Approximately 9 hours (low), 7 hours (high)
- Dimensions:66 mm x 92.3 mm x 22.5 mm (W x H x D)
- Net Weight:80g